Tempco Logo

TEMPCO Electric Heater Corporation
Radiant Heaters

Home | Arrays Hub

ARA Array Assemblies for CRD E-Mitters®



 Design Features
  • Lightweight extruded aluminum outer housing
  • All metal interior components are stainless steel.
  • Designed for use with E-Mitters Style CRD
  • Each heater’s power leads are connected to an individual ceramic Terminal Block.
  • Nickel wire with heat resistant insulation is used for circuit wiring between terminal blocks.
  • Zones with different radiant heat levels can be achieved by using different wattage heaters (each zone would have a heater with built-in thermocouple for temperature control).
  • Shipped fully assembled
  • Optional factory wiring and power control panels
  • Optional ceramic fiber insulation in wiring space
  • Optional entrances in rear cover or sides to customer specs

The housing for the CRD heaters is the same construction as all CRA arrays except for the extra height needed for the long shaft of the CRD heaters. This space is then filled with ceramic fiber insulation with foil backing to keep the wiring and terminal area much cooler.

ARA Structural Housing Array Dimensions for CRD E-Mitters


CRD
(4.80" × 4.80")

Ordering Information
Refer to The following Worksheet to place an order:
ARA Array Panel Design Worksheet for Ceramic or Quartz E-Mitters®