Home | Back to Strip Heaters Selector | Back to Channel Strip Heaters Main Page

Ceramic Insulated Channel Strip Heaters
Lead Wire Terminations

Terminal box,
High Temperature Quick Disconnect Plug
Specially designed box welded to Channel Strip Heater		 Flexible lead wires,
Right-angle armor cable,
Wire braid

 

Type C__

 Terminal box has a 5/8" knockout. Box provides excellent protection to exposed terminals. If armor protected lead wires are required, specify armor and lead length. Available on 1" and 1-1/2" wide heaters.
Type CA No cable or braid
Type CB Galvanized cable
Type CC Stainless steel cable
Type CD Wire braid
 
 
 
 

Type P__

 High Temperature Quick Disconnect Plug. If armor protected lead wires are required, specify armor and lead length. Available on 1-1/2" wide heaters only.
Maximum Amps: 15 at 240VAC. Maximum Volts: 240.
Type P1A Cup only (UT900)
Type P1B Cup and straight plug (H900)
Type P1C Cup and 90° plug (HW900)
Type P1D Cup, straight plug and galvanized cable
Type P1G Cup, 90° plug and galvanized cable
 
 
 
 
 
 

 
 

Exposed electrical wiring on Strip Heaters is a violation of electrical safety codes including O.S.H.A.

 

Type MP__

 Specially designed box is welded to the Channel Strip Heater and potted with epoxy. The ends of the heater are also welded. Leads exit through a 1/2" NPT nut that can be located at the top or in the front of the box. Armor cable can be supplied with the male fitting, providing a completely sealed Channel Strip. Available on 1-1/2" wide heaters only. 10" long leads standard; if longer leads are required, specify. Maximum Amps: 25. Maximum Volts: 480.
Type MPA Box only
Type MPB Box with prewired galvanized cable
Type MPC Box with prewired stainless steel cable
Type MPD Box with prewired wire braid