Home | Back to Strip Heaters Selector | Back to Channel Strip Heaters Main Page

Ceramic Insulated Channel Strip Heaters
Lead Wire Terminations

Flexible lead wires,
Right-angle armor cable,
Wire braid		 Terminal box,
High Temperature Quick Disconnect Plug,
Specially designed box welded to Channel Strip Heater

 

Type L

 Flexible lead wires exit from end of heater. 10" long leads standard;
if longer leads are required, specify. Recommended only for tight quarters or where flexibility of the lead wire is required. Not available on heaters with tabs.
Maximum Amps: 10 at 240VAC. Maximum Volts: 240.
 
 
 

Type L1

 Flexible lead wires exit from top of heater. 10" long leads standard; if longer leads are required, specify.
Maximum Amps: 10 at 240VAC. Maximum Volts: 240.
 

Type R2__

 Right-angle armor cable prevents contamination from getting into the heater. 10" of armor over 12" long leads is standard; if longer leads or armor are required,specify.
Maximum Amps: 10 at 240VAC. Maximum Volts: 240.
 
 
Type R2A Galvanized cable
Type R2B Stainless steel cable
Type R2C Elbow and leads only (no cable)

Type W1

 Wire braid provides strength and protection to the lead wire insulation, offering sharp bending not possible with armor cable. 10" of wire braid over 12" long leads is standard; if longer leads or braid are required, specify.
Maximum Amps: 10 at 240VAC. Maximum Volts: 240.