Type N - (Standard) External Pins with Leads Flexible stranded nickel leadwires have fiberglass insulation and are U.L. approved for 600 volt or 300 volt service. The leads are connected to 1 1/4" (32 mm) long solid nickel conductors. Fiber-glass sleeving insulates the pin/lead wire connection.
	Type F - Internally Connected Flexible Leads This lead termination provides greater flexibility adjacent to the heater by allowing the lead wires to be sharply bent as they exit the heater. Temperature at the lead end is not to exceed 482 degrees F (250 degrees C). Standard - 10" leads. If longer leads are required - Specify. Amperage Limitation for Type F Diameter 1/4" 5/16" 3/8" 1/2" 5/8" 3/4" Maximum Amperage 2.5 2.5 4.0 7.0 10.0 10.0
	Type M2A - Potted Lead End Seal Cement potting with silicone varnish. 1000 degrees F (538 degrees C). Fiberglass lead wires externally connected. Cement potting helps to protect the heater from minor contaminations from plastic material, cleaning solvents, or oils. Standard - 10" leads. If longer leads are required - Specify.
	Type P - Quick Disconnect Plugs (SELECT PLUG TYPE AND CABLE TYPE FROM CHARTS BELOW) Allows for the quick and easy replacement of the heater. The plug can be attached to fiberglass leads, galvanized armor cable or stainless steel armor cable.
	Plug Type 1 2 pole/2 wire twist locking plug 15 amp 125 volt, NEMA L1-15P 2 2 pole/3 wire twist locking plug 15 amp 125 volt or 10 amp 250 volt, NEMA N/A. This plug is not UL listed. It should only be used for existing receptacles, not for new installations. 3 2 pole/3 wire straight blade plug 15 amp 125 volt, NEMA 5-15P 4 2 pole/3 wire twist locking plug 15 amp 125 volt, NEMA L5-15P 5 2 pole/3 wire twist locking plug 15 amp 250 volt, NEMA L6-15P Cable Type A Plain fiberglass leads B Galvanized steel cable C Stainless steel cable D Stainless steel overbraid