The heater power is independent of the console controller input power. A Solid State Relay closure is provided per zone for external control switching.
Each zone is fused at 15 Amps. External 120, 208 or 240 VAC must be provided to the heater power circuit.
You must install a switch into the heater circuit to disconnect power to the heater output when the console is not in use. The internal solid-state relay should not be relied on to disconnect heater power.
4-7/8" H × 9" D × 5" W
4-7/8" H × 9" D × 11-1/4" W
4-7/8" H × 9" D × 8-1/4" W
4-7/8" H × 10" D × 14-13/16" W
- Output Power Switching: Solid State Relay with heat sink
- Optional Sensor Inputs: Consult Tempco
- Power Input: Rear panel mounted fused power inlet, cord supplied
- Control Options: FM High Limit Controller, 2nd Output, Alarm, Data Communications or other special requirements; consult Tempco.