Custom products are Tempco's specialty. Browse our portfolio below for inspiration.
Cartridge heater for continuous air heating application with Incoloy® sheath, custom machined fitting and silicone rubber moisture barrier
Heater for medical diagnostic instruments has an integrated heat sink and thermal fuse
Heater with custom designed fins for air heating in natural convection environment in a plastic-processing machine
Complex shape cartridge heater
Heater designed to run continuously at 1202°F (650°C); designed with built-in isolated thermocouple and ground wire
Heater with NPT fitting and 5-pin industrial connector molded to the cord
Designed with straight armor cable and adjustable bayonet cap for easy assembly
Incoloy® fitting and seamless Incoloy® 800 sheath material used in an aviation application
SJO cord and molded plug termination for automotive air conditioning recharging units
SJO cord and molded plug termination for automotive air conditioning charging units
Finned cartridge oil immersion heater with liquid-tight electrical termination
Internal thermocouple is wired to a serial connector for easy assembly to a microprocessor used in incubators
Pennybottom tip die bolt heater with internal thermocouple
Heater with built-in thermal fuse and ground wire for X-Ray processing equipment
Heater with built-in thermostat, pipe fitting and ground leads for oil heating in waste handling equipment
The header cap of this heater is an integral part of the fitting; leads exit through small holes that are sealed with epoxy for moisture protection
607 N. Central Ave. | Wood Dale, IL 60191-1452 USA Phone: 630.350.2252 | Toll Free: 888.268.6396 Fax: 630.350.0232 | Email: [email protected]
DISTRIBUTOR LOG-IN Authorized SA3 Distributor Log-In
ISO 9001:2015 Certified Company
Privacy Policy Cookie Policy Do not sell my information
TEMPCO BRANCH OFFICES We have Branch Offices located across the United States.